TL 11

[teenu3]

thread806-952928,

hi,

how to adjust vari,varo in bp250 trunks.

regards

 

[doktor]

You need to remove the trunks (TRU - programmed lines before). ROEQE:ROU=, TRU=;
Then you can change VARI, VARO and VARC by means of RODAI. The command RODAC does not exist.

///doktor

 

[himdp]

Do you mean you want to set up analogue trunks in a BP250?

 

[teenu3]

hi himdp;

yes that is what i mean.

because few days back i was in a site. there they have 4 lines from v-sat modem. all 4 line working with normal analog phone.
those line when connected to bp 250 thru btu a . the in comming is okey. but no out going. when u dial '0,
you will get external tone. further i canot dial. the dial tone is not cutting. i am looking for a solution.

regards

 

[himdp]

That being the case, I believe that the title of your post is not helpful.
TL11 is the function block for certain types of analogue trunk on MD110/Telephony Switch and has no relevance on BP250.
It is possible that people able to help you will not even bother to read this post. I cannot help with BP250 and if you do not get a reply to this question from someone else, perhaps you should start a new thread with a BP250 specific title. Just a thought

 

[teenu3]

THANKS HIMDP