Time on Handsets has stopped 1

[woodlandsniceguy]

We shut our BCM450 down to move into a new rack. It was down for a day. When it came back up all was fine except that all handset time diplays were off by a couple of hours verses the BCM clock.

I tried updating the time on the BCM but it has remained the correct time but will not push its time to the handsets.

I tried using the telset commands to update the time which works but then the time never changes. It has been on the same date and time since 24 hours ago.
It was originally set to NTP. I tried Trunck and manual but nothing will push to the phones.

Not sure where to look now.

 

[woodlandsniceguy]

I just noticed that when I change the system date and time using the handset it updates the time on the BCM. But at that point the BCM continues keeping time but the habdsets all remain frozen at the same time.

 

[hototot]

what release? I think there was a patch for that.

 

[norstarboy125]

I'd check on the patch and also power cycle it again.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[woodlandsniceguy]

A reboot of the BCM corrected the issue.