Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Time of dialing 1
- Thread starter Provax
- Start date
-
1
- #2
If I understood right, there is a timer:
CTIME:TYPESWU=CP1,LCREOD=5;
The HiPath 4000 uses the timer LCREOD (least cost routing end-of-dial) to determine whether a 5 digit number is dialed.
If there is no other digit dialed within this timer (or if the user dials the pound "#'), the HiPath 4000 assumes that all digits are dialed and routes them accordingly.
This timer is restarted after each digit dialed.
Upon expiry of the timer, it is assumed that dialing has been completed.
CTIME:TYPESWU=CP1,LCREOD=5;
The HiPath 4000 uses the timer LCREOD (least cost routing end-of-dial) to determine whether a 5 digit number is dialed.
If there is no other digit dialed within this timer (or if the user dials the pound "#'), the HiPath 4000 assumes that all digits are dialed and routes them accordingly.
This timer is restarted after each digit dialed.
Upon expiry of the timer, it is assumed that dialing has been completed.
- Status