Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Timberwolf 9730 Tape Library

Status
Not open for further replies.

brianking

IS-IT--Management
May 25, 2002
1
0
0
GB
My tape library has an error message on the front panel, can anyone share some light.

INOP = FSC#3329
MECH = NONE

 
There are four possible causes in percentage of possibility:-
FSC: 3329
Microcode Level: ALL

Family ID: 314
Device Desc: 9730

Probability: 50%
Callout: HAND ASSY
CSE Description: ERR_AUD_CALIBRATION_FAILURE, Note: In the CAP open position the CAP mechanism blocks the calibration label. If the CAP is opened close it and then open and close the door to re-start the initialization. The camera calibration routines couldn't find a valid operating point. This may be because the calibration label is not installed, installed improperly or the camera and/or related circurity is not working.
-----------------------------------------------------------
FSC: 3329
Microcode Level: ALL

Family ID: 314
Device Desc: 9730

Probability: 25%
Callout: CYC
------------------------------------------------------------
FSC: 3329
Microcode Level: ALL

Family ID: 314
Device Desc: 9730

Probability: 24%
Callout: CALIBRATION LABEL.
-----------------------------------------------------------
FSC: 3329
Microcode Level: ALL

Family ID: 314
Device Desc: 9730

Probability: 1%
Callout: Logical error

------------------------------------------------------------
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top