Don't know if this is the right forum but if not perhaps someone could refer me to where I should post. I am making a letterhead which includes the top the bottom and a side bar on the right. I have made this using Illustrator 10 with a document setting for letter size (8.5 x 11). It prints out beautifully! So then I save it as a tiff and put it into use using word. However, this is where the problem arises...when I import it into word it does not fill the page as it had in illustrator. Am I doing something wrong in the way I'm saving it or something along those lines? Any help or suggestions would be greatly appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tiff question
- Thread starter kh707
- Start date
It's Word that's shrinkning it. When you place a graphic in Word it will resize it down to the width of your margins for the document. Just pull your margins right out to the edge of the page BEFORE you place the graphic, then it will come in at it's full size.
- Status
Similar threads
- Locked
- Question