Tie lines

[thephonelady]

Anyone out there remember E&M tie lines for a Magix??
I know they are a 4 wire ckt and I have a cust. talking about a 2 wire tie line- will that work in a Magix using a Tie line ckt board??
It's hard to find any info about this on the AVAYA site.
Thanks!

 

[SYQUEST]

There are 2-wire E/M circuits, but the module for the Legend/Magix I believe is only for 4-wire E/M circuits. I will check my references and post back.

Can you get anymore info from the customer?
Do the 2-wire E/M circuits currently exist inservice?

....JIM....

 

[SYQUEST]

It looks like the 400EM Tie Trunk Module is only a 4-wire TX/RX transmission device with dip switch settings for E/M signaling options. Each module provides four circuits.

Hope that helps!

....JIM....

 

[thephonelady]

After talking to the cust a bit more I found out that he is talking about a point to point T1 & not E&M tie lines. Is this doable connecting to a ROLM system using a 100D board? I have always done this AVAYA to AVAYA.
Thanks!

 

[CarGoSki]

Wow.. good luck with that.

 

[CarGoSki]

Perhaps you could talk to the Rolm guy to see if he can connect to IP Office. If so you could spend a few $$ and put IPO on the ROLM side to connect to Merlin via point to point. There is a tech tip for that.

Otherwise you may be able to back into it by setting Merlin to Mer-Network and having the ROLM set to Digital Tie Lines. The merlin would have to operate on "extension to match.

 

[mforrence]

So long as you're emulating standard tie lines, it should work fine. At least the Magix end will be fine.
Mike

 

[SYQUEST]

The Legend Network Reference document is a good resource for reviewing your networking options and capabilities for the Magix.

....JIM....