tie line 2

[ertebetgostarnil]

hi everyone
i a have one network with two tda200 this pbx tie with 2 ipgw16(0490) without access code method
everything is ok but i cont use (Blocking trunk calls made through another PBX and how to override it)feature how can config it ?when i dail * key bpx send reorder tone
thank
Blocking trunk calls made through another PBX and how to override it:
Whether an incoming TIE line call can make a trunk call through this PBX (i.e., PBX-2), depends on the
COS that is assigned to the trunk group of this PBX, that the incoming TIE line is connected to. If the COS
of the trunk group is unable to make outgoing calls by the Toll Restriction/Barring feature or External Call
Block feature, trunk calls made through this PBX will be prohibited.
To override this prohibition, an extension of PBX-1 must enter a verification code assigned to PBX-2 to
change the COS temporarily. It is also possible to override the prohibition by specifying an extension at
PBX-2 with the Walking COS feature, to temporarily switch to that extension’s COS.
® 4.12 [2-7-1] Class of Service—COS Settings—TRS— TRS Level—Day, Lunch, Break, Night
® 4.13 [2-7-2] Class of Service—External Call Block
® 5.1 [3-1-1] Trunk Group—TRG Settings—Main— COS
® 8.3 [6-3] Verification Code
® [500] Trunk Group Number

 

[cwc3]

do you have the number to panasonic tech support ?

http://www.thetelephonemanonline.com

 

[cwc3]

heres an old trick though trs settings can be overidden by speeddial numbers

http://www.thetelephonemanonline.com

 

[DanBailey87]

have you tried setting trunk group 7 (the tie line) to COS 1?

in default its in COS7 which wont allow trunk calls over the GW

3.Group
1.Trunk Group
1.Trunk Group Settings

 

[ertebetgostarnil]

thank for help
how can override special number(# or *)in trs setting?
i check 7-5 in maitanace consol (trs ceck for dial (* or #)is no check and my cos of gw trg is 1
Thang for reply