We have a T1 that we use for outgoing long distance. Occasionally when I look at the channels, I'll see two channels "looped" together, like this:
-----------------------------------------
>ld 80
.trad 7 24
ACTIVE TN 007 24
ORIG 007 24 TIE RMBR 7 24
TERM 007 23 TIE RMBR 7 23
DIAL DN 617467636544
MAIN_PM ESTD
TALKSLOT ORIG 17 TERM 19
EES_DATA:
NONE
QUEU NONE
CAMP
CALL ID 0 904
PDCA 1 PAD 0 0 PCML MU MU
PDCA 1 PAD 0 0 PCML MU MU
-----------------------------------------
If I disable, then re-enable either channel it will disconnect this "loop", and all is fine again, until the next time this happens.
Any ideas on how this could be happening? If I don't keep an eye on this, resetting channels when needed, I've seen up to 10 channels of the T1 have these pair loops.
Thanks,
Dean G>
-----------------------------------------
>ld 80
.trad 7 24
ACTIVE TN 007 24
ORIG 007 24 TIE RMBR 7 24
TERM 007 23 TIE RMBR 7 23
DIAL DN 617467636544
MAIN_PM ESTD
TALKSLOT ORIG 17 TERM 19
EES_DATA:
NONE
QUEU NONE
CAMP
CALL ID 0 904
PDCA 1 PAD 0 0 PCML MU MU
PDCA 1 PAD 0 0 PCML MU MU
-----------------------------------------
If I disable, then re-enable either channel it will disconnect this "loop", and all is fine again, until the next time this happens.
Any ideas on how this could be happening? If I don't keep an eye on this, resetting channels when needed, I've seen up to 10 channels of the T1 have these pair loops.
Thanks,
Dean G>