Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
thin client
- Thread starter wmiller
- Start date
The thin client that would be loaded for instant access is a bit large , the only way to do this would be to have a EPROM programming machine.<br>
Having one of those available , then you would need to have the thin client put through a machine code generator. If you have the resources this can be a very cost effecitve way of getting the units on line , however if you do go this route; start by using EEPROMS . These are just as fast as EPROMS but can also save money while tweaking the software loads.<br>
<br>
An alternative way would be to use batch files with 2 floppy drives to load the necessary drivers and network attachments. This is also another way to test the software loads Before loading them into an EPROM.<br>
<br>
Good luck;<br>
<br>
Having one of those available , then you would need to have the thin client put through a machine code generator. If you have the resources this can be a very cost effecitve way of getting the units on line , however if you do go this route; start by using EEPROMS . These are just as fast as EPROMS but can also save money while tweaking the software loads.<br>
<br>
An alternative way would be to use batch files with 2 floppy drives to load the necessary drivers and network attachments. This is also another way to test the software loads Before loading them into an EPROM.<br>
<br>
Good luck;<br>
<br>
- Status
Similar threads
- Locked
- Question