Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

TGAR and TARG Don't match but get reorder tone when dialing ACOD

Status
Not open for further replies.

dabble

Technical User
Jun 15, 2005
594
CA
I have a CS1000 at 7.6
Below is a printout of my set showing my TGAR set to 1

DES 5THFLR
TN 152 0 00 06 VIRTUAL
TYPE 1140
CDEN 8D
CTYP XDLC
CUST 0
NUID
NHTN
CFG_ZONE 00001
CUR_ZONE 00001
MRT
ERL 101
ECL 0
FDN 4000
TGAR 1
LDN NO
NCOS 4
SGRP 0
RNPG 0
SCI 0
SSU
LNRS 16
XLST
SCPW 4316
CLS CTD FBD WTA LPR MTD FNA HTA TDD HFA CRPD
MWA LMPN RMMD AAD IMD XHD IRD NID OLD VCE DRG1
POD SLKD CCSD SWD LNA CNDA
CFTD SFD MRD DDV CNIA CDCA MSID DAPA BFED RCBD
ICDA CDMD LLCN MCTD CLBD AUTU
GPUD DPUD DNDA CFXD ARHD FITD CLTD ASCD
CPFA CPTA ABDD CFHD FICD NAID BUZZ AGRD MOAD AHD
DDGA NAMA
DRDD EXR0
USMD USRD ULAD RTDD RBDD RBHD PGND OCBD FLXD FTTC DNDY DNO3 MCBN
VOLD VOUD CDMR PRED RECD MCDD T87D SBMD
KEM3 MSNV FRA PKCH MUTA MWTD DVLD CROD ELCD VMSA
CPND_LANG ENG
RCO 1
HUNT 4000
LHK 0
PLEV 02
PUID
UPWD
DANI NO
AST
IAPG 0
AACS NO
ITNA NO
DGRP
MLWU_LANG 0
MLNG ENG
DNDR 0
KEY 00 SCR 4316 101 MARP


Below is a printout of my route 40 with a TARG of 4

TYPE RDB
CUST 00
ROUT 40
DES MOH
TKTP MUS
NPID_TBL_NUM 0
VTRK NO
NODE
CNDP UKWN
ICOG OGT
SRCH LIN
STEP
BDCT NO
ACOD 4041
TARG 4
CLEN 1
OABS
TIMR ICF 512
OGF 512
EOD 13952
DSI 34944
NRD 10112
DDL 70
ODT 4096
RGV 640
GRD 896
SFB 3

IENB 5
SST 5 0
NEDC ETH
FEDC ORG
HOLD 02 02 40
SEIZ 02 02
RGFL 02 02
CDR NO
MUS NO
TTBL 0
OHTD NO
ALRM NO
SGRP 0
ARDN NO
CTBL 0
AACR NO


When I dial the ACOD of 4041 from my set, I get reorder tone and I don't understand why since the TARG and TGAR don't match therefore the call should go through.

Any thoughts?
Thanks.,

 
UPDATE - when I dial this ACOD of 4041 from a digital set that has the same TGAR of my set, I get through successfully.

Is there a difference with the TGAR / TARG when IP sets are involved?

Thanks.
 
Changed the CLS to UNR - still get reorder tone.
 
TGAR and TARG applies to all sets the same, IP, digital and analog. I would to a trace on the IP set and see what is going on.
 
Since you appear to be calling from IP phone to TDM music it might be that you need to have a music trunk in the same network group as your media gateway card. Or change the route to broadcast (BDCT YES).
 
YEAH! I changed the BDCT prompt from NO to YES and it worked!
Thank you so much!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top