Test Trunk Definity G3Si

[Mulligans]

I am trying to do some testing on a new PRI I just installed, can anyone tell me how to send a call out a specific trunk? Like I want to call my cell phone and make sur eit goes out trunk 4, the new PRI.

 

[mikeydidit]

While you can on CO trunks using a verify button, its not going to be easy on the PRI. The only way I know would be the busy out the other members.

"A people that values its privileges above its principles soon loses both."
- Dwight D. Eisenhower (1890-1969), Inaugural Address, January 20, 1953

For the best response to a question, read faq690-6594

 

[dhotep]

mikey is right. I asked this a while back (what you want to do is called Facility test calling) and it cannot be done on a PRI circuit.

http://www.tek-tips.com/viewthread.cfm?qid=1517141&page=1

In my case I was adding members to a trunk and needed to make sure the new members were live. If you are bringing up a whole new trunk, create a route that uses that trunk then just add an ARS entry for your complete cell number and use that route. if the ARS entry is for your complete number, it will not affect other routing.

 

[jdeadly]

Try List trace sta and the staion you are calling from

 

[Mulligans]

Thanks for the help, I ended up not needing it, just added some of the ports to a production trunk group and they started getting used, one way to test.