Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Test All command
- Thread starter E3p0
- Start date
- Thread starter
- #3
It could be the prom version . I think the latest stand alone flash PROM update is 106121-16.
Normally if I want to run the POST diags I set the diag-level to max and the diag-switch to true.
When the diag switch is set to true the system will try to boot from the net when the POST is finished. You can break out of this by issung the break sequence.
I have seen this problem in the past and just don't run the test-all command. You can run sunvts online to shake out the system once it is booted and use the POST diags to ascertain the system is ready to boot.
Normally if I want to run the POST diags I set the diag-level to max and the diag-switch to true.
When the diag switch is set to true the system will try to boot from the net when the POST is finished. You can break out of this by issung the break sequence.
I have seen this problem in the past and just don't run the test-all command. You can run sunvts online to shake out the system once it is booted and use the POST diags to ascertain the system is ready to boot.
- Status