Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

terminfo/termcap problem

Status
Not open for further replies.

sgallup

MIS
May 10, 2010
1
US
I have recently converted a server running HP-UX 11i v2 with IDS 10 to HP-UX 11i v3 with IDS 11.5.
When I run a 4gl program that has a form within a window the window border is displayed incorrectly i.e.
upper left = 2
lower left = 1
upper right = 3
lower right = 5
horizontal = z
vertical = 6
The problem occurs with termcap and terminfo. It appears that the terminal will no longer recognize the commands to enter graphics mode.
The terminal type is wy50 (wyse50).
Has anyone experienced this issue and/or have any ideas for a solution?
Thank you.
 
any ideas for a solution
Check the values of the INFORMIXTERM, TERMCAP and TERMINFO variables.
Check that the wy50 entry of the the relevant termcap file contains the following:
:gs=\EH^B:ge=\EH^C:gb=2135\0726:\
:G1=3:G2=2:G3=1:G4=5:\
:GC=8:GD=0:GE=\EH^C:GF=7:GG#0:GH=\072:\
:GU==:GV=6:GR=4:GS=\EH^B:GL=9:\

Hope This Helps, PH.
FAQ219-2884
FAQ181-2886
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top