Hi Guys
I have a rather strange problem with one of our client's networks. We have recently implemented a dial-in VPN using client v4 to their PIX 515. They also have 2 site to site tunnels to other offices.
Everything is ok until the split-tunnel command is enabled for the dial-in VPN. When this is configured, all users can connect to the VPN, but some can't connect to the terminal server (using the internal address). They get an error saying it is busy. However, other users can connect. I don't think it is a problem with the pix config.
All remote users are on broadband connections.
Anybody any ideas?
cheers
kirby449
I have a rather strange problem with one of our client's networks. We have recently implemented a dial-in VPN using client v4 to their PIX 515. They also have 2 site to site tunnels to other offices.
Everything is ok until the split-tunnel command is enabled for the dial-in VPN. When this is configured, all users can connect to the VPN, but some can't connect to the terminal server (using the internal address). They get an error saying it is busy. However, other users can connect. I don't think it is a problem with the pix config.
All remote users are on broadband connections.
Anybody any ideas?
cheers
kirby449