telset commands

[PBXT3CH]

on phones through BCM. Where can one find the documentation on this?

thanks in advance,
-pt.

 

[BombOne]

are you asking about a 200, 400, or 50, or what?

 

[countrytime]

What version? I believe telset admin is only supported on the 4.0, for 200 and 400 and 2.0 for the 50. There are no commands, per se, you just login and progress through a menu, responding to the displayed prompts.

 

[BombOne]

it hasnt been suported but youve always been able to do it, its been a while but its either f**admin, or F**system then the installer password, has worked on bcm 2.5-3.7, it became more complex in 4.0 you need a user name and password.

 

[BombOne]

I tested it today on a BCM 3.6, it is feature ** system then the CONFIG password.

 

[DigitelD]

Nortel does not support or recommend telset on 3.7 and lower. They have their reasons for it. It can and has caused data corruption on the systems. They can definitely tell if you have used **system and if you have trouble due to that you are out of luck.

SHK Certified (School of Hard Knocks)