Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Telnet into single user mode server steps

Status
Not open for further replies.

shaife

MIS
Mar 16, 2010
5
EU
Hi
I need to run Solaris 10 SPARC Recommended Patch Cluster on a remote T2000 T1000 servers .
I would to take down the servers into a single user mode and then to make the installation.
I don't have a console to those servers.
What are the steps in order to have a telnet to those servers after taking them down into single user mode .

Thanks
 
hi,

to connect to the servers remotly (if they r in single user mode), configure the ALOM port. this port is located at the back of the server. normally it called net mgt.

regards,
Houssien Sleem
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top