Telnet access on a BCM 4.0 System

[Firebird Scrambler]

Hi Folks

I've been trying to set-up a Telnet access via my Procomm plus comms program. I've been OK on my BCM 3.6 & 3.7 systems, but it seems that there are new parameters such as Inbound Filters etc to deal with. Has anybody been able to get it to work yet?.

Thanks


All the best

Firebird Scrambler
Meridian Programmer in the UK

http://mysite.orange.co.uk/firebird_scrambler

Useful Nortel forum at

http://www.tspforum.com

If it's working, then leave it alone!.

 

[steeef]

console access via telnet or ssh is not possible on BCM4 or BCM50. Only for nortel support

 

[Firebird Scrambler]

Thanks for the reply.

That's odd that you can't access the BCM via Telnet anymore. It was quite handy when I needed to check or change the IP address's etc.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://mysite.orange.co.uk/firebird_scrambler

Useful Nortel forum at

http://www.tspforum.com

If it's working, then leave it alone!.