Tektronix Phaser 350

[jakrabit]

try as i might, i cannot seem to find the translation to this error code on my Phaser 350

"fault 07,004.46:33829"

any suggestions? Shane
and now for the impressive abbreviations:
DOA, SOL, AWOL, PEBKAC, id10t, FUBAR

 

[JimboJ]

Did you ever receive an answer? I am now having the same problem except the last number on the fault message are 110904.

 

[Guest_imported]

Go and have a look at the following URL. Choose the product, then use the wizard to home in on the error / fault code:

http://www.officeprinting.xerox.com/infoSMART/

Jim Brown,
Johannesburg,
South Africa.
My time is GMT+2

 

[MDA2]

error 7,004.46: No transitions are obeserved of the drum maitenance cam sensor. The sensor may be bad or the cam maybe jammed...

This error indicates a DMC failure. Replace the cam. It is cheap and takes a whole 5 minutes..

I can get parts BTW

pnewby@ccgx.com

 

[Nova7]

I have a fault code of 04-005-44-14942 on a Phaser 350.
Can anyone tell me what the code is/means/translates to and which FRU may need swapped?
Danka, Nova7.

 

[lucosta]

my printer shows this error code 7,004.46: 33829" what may be wrong and what is the cam drum

 

[Nova7]

It appears that there are a lot of questions here and not too many answers. If someone knows whats up w/ my question, please respond.
Thanks, Nova7.

 

[MDA2]

4,005.44= Failure postioning drum maitence cam during a drum maintence cycle: check drum maitence cam solenoid, clutch, homer sensor, and related software..

The Drum Maitenance clutch has several error codes and is a very common part to fail.

 

[Nova7]

Thanks MDA2, I appreciate it and hopefully will be able to get this thing going.
Nova7.