I just bought a Tektronix phaser 350 on ebay. I also invested in about $300 in extra ink sticks and a couple of maintanence trays. when I trun the system on, it starts to initialize and gives me the fault "04,005.44:7418" What does this mean? I have replaced the maintenance tray with no change. I have about $480.00 invested in this printer and was planing on using this with the business I am starting.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tektronix 350 error message HELP!!!
- Thread starter travGPS
- Start date
Error: Failure positioning drum maintenance cam during a drum maintenance cycle: check drum maintenance cam soleniod, clutch, home sensor, and related hardware.
More than likely the problem is the clutch. The drum maintenance clutch is a spring wound clutch and the yellow grease used on them would get hard. Sometimes just cleaning and relubing would do the trick. Later
More than likely the problem is the clutch. The drum maintenance clutch is a spring wound clutch and the yellow grease used on them would get hard. Sometimes just cleaning and relubing would do the trick. Later
- Status
