Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

TDA30 won't release lines after divert

Status
Not open for further replies.

tubdub

IS-IT--Management
Jan 5, 2012
38
GB
Have just set up an external divert on a TDA30 which is working, but once the call is finished the system is not releasing the lines. It's as if the system has not detected the calls have finished.

Just did a test and even after unplugging the lines and reconnecting them, the system still sees them as in use. After 10 mins I had to power cycle the machine just to get the use of the lines back.

TDA30 with TVM50, analoge POTS lines.

Any ideas? I'm pulling my hair out!
Many thanks

 
If you don’t have cpc signal on the analogue line it won’t know the call has ended so will not clear down. You could set co to co timer to lower than 10 minutes so the call is disconnected after a few minutes

We would normally only do this option with isdn
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top