TDA 50 to TDA 50 over Point to Point T1

[SpecializedTech]

I'm working on a site. We installed a TDA 50 with a TDA5480 VOIP Gateway Card at each location. The two sites were up and running with the exception of voice quality, when connected over the internet thru dsl. We are in the process of ordering a point to point t1 to connect the two sites. Is there any additional equipment needed to make everything work thru the t1.

 

[cwc3]

an adtran ace on each end

 

[SpecializedTech]

With the Adtarn Ace, are there any special settings that need to be used to have them communicate between the two sites.

 

[SYQUEST]

You need to set the parameters of the Adtran CSU to match the specs of the DS1 ordered and the Panasonic TDA50 configuration.

READ the documentation that comes with the unit and follow the instructions.

Hope this helps!

....JIM....

 

[SpecializedTech]

I was supplied with two Netopia Routers to connect the two sites and have them see eachother. I follow the directions for logging into the routers, but was unsuccessfull. Is there any other software I may need to use, any help is greatly appreciated.

 

[cwc3]

most are browser based what does your docs say!