Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Target lines for MICS 1
- Thread starter jabbst
- Start date
-
1
- #2
norstarboy125
Vendor
it depends on the software version
most older were ln.121-
newer were ln.145-
newest i believe ln.157-
easy way just show the line number then hit show again and it will tell you target line etc.
most older were ln.121-
newer were ln.145-
newest i believe ln.157-
easy way just show the line number then hit show again and it will tell you target line etc.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
