I have a full blown MICS with 5.0 XC software. It has 2 T1 cards and 9 M0x16 station modules on it. I believe the target line range is line 145 to line 337. The problem that I am having is that target lines 314 and above do not seem to work. I can see them in programming as target lines and I can program the target line but it doesn't work. I know it's not the DID number, because I can program that same DID number on a target line under 314 and it works. I have rebooted the system a couple of times and still no change. Target lines 145 thru 313 work fine. Any help or suggestions would be greatly appreciated. Thank.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Target line range on MICS 5.0 XC software
- Thread starter SkiDog
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
