Guest_imported
New member
- Jan 1, 1970
- 0
Hi,
We've been installing SP3 for Arcserve 2000 this evening, and after the installation the Tape Enginge failed to start. The following error was displayed:
The ordinal 4805 could not be located in the dynamic link library TAPEENG.DLL
The solution is as follows:
Start the installation of the SP again. When the needed files are extracted (at the point the actual install. starts), open C:\TEMP\pftAD~tmp\ARCserve\Data.Cab and extract the F4151_tapeeng.dll file from it. Rename the file to tapeeng.dll and replace the original tapeeng.dll (in the root of the Acrserve dir.) with it.
We've been installing SP3 for Arcserve 2000 this evening, and after the installation the Tape Enginge failed to start. The following error was displayed:
The ordinal 4805 could not be located in the dynamic link library TAPEENG.DLL
The solution is as follows:
Start the installation of the SP again. When the needed files are extracted (at the point the actual install. starts), open C:\TEMP\pftAD~tmp\ARCserve\Data.Cab and extract the F4151_tapeeng.dll file from it. Rename the file to tapeeng.dll and replace the original tapeeng.dll (in the root of the Acrserve dir.) with it.