Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tail End Hop Off on S8720 R3.1.5 using H.323 Tie trunks

Status
Not open for further replies.
Tripp74

Tripp74

Technical User
Aug 27, 2009
13
US
Hello, I am being asked to allow TEHO from the company's Cisco PBX in Australia using the existing H.323 trunks.For testing,a route in the Cisco switch has been set up to send the last 11 digits,(1419.819.xxxx) however when I do a list trace on the TAC, I'm only getting the first four digits (1419) and the call goes to our operator since we don't have a X1419. I've looked at the incoming call routing table, but other than inserting a "9" for outbound, I don't see that helping me. I'm thinking the trunk group need to be tweaked to allow all 11 inbound digits.
Any help would be appreciated.

Thanks,
Jim
 
Status
Not open for further replies.

Similar threads

NewNic
  • Locked
  • Question
h.323 tie line locked up
Replies
0
Views
98
NewNic
NewNic
wallot
  • Locked
  • Question
Changing from H.323 to SIP on J100s
Replies
0
Views
122
wallot
wallot
hcmbmt
  • Locked
  • Question
Uniform dialing plan via H.323 between CM and IPO not working
Replies
1
Views
167
hcmbmt
hcmbmt
DTDude
  • Locked
  • Question
H.323 trunk fast start / early media
Replies
0
Views
125
DTDude
DTDude
J
  • Locked
  • Question
Custom CMS Report based off of Historical Skill report
Replies
0
Views
305
Jimbojambo
J

Part and Inventory Search

Sponsor

Back
Top