Tab Control

[Rich8541]

Hello, I'm using access 2003. I added a tab control to an existing db I use for tracking contractors and work hours, benefits, etc. I added the tab to an existing form, cut and pasted the existing controls so they were where I needed them but they didn't work. I had to reset the event procedures for each control.Any way to avoid this in the future?
Thanks Jim

 

[RuralGuy]

It is the Cut and Paste that "unhooks" the event code but it is the only way to get your controls on the tab you want. If you had placed the TabControl before creating the controls, you would not have had the problem.

(RG for short) aka Allan Bunch MS Access MVP acXP, ac07 ac10 - winXP Pro, Win7 Pro
Please respond to this forum so all may benefit