Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
T1 without E&M Signaling
- Thread starter samelbe
- Start date
- Moderator
- #2
If I remember correctly, a T1 can have an E&M Wink, *OR* a pseudo-loop.... sorry I can't be of more help than that.
Just my 2¢
"What the captain doesn't realize is that we've secretly replaced his Dilithium Crystals with new Folger's Crystals."
--Greg
Just my 2¢
"What the captain doesn't realize is that we've secretly replaced his Dilithium Crystals with new Folger's Crystals."
--Greg
MrComputerTelephony
Vendor
Have you been using E&M and the existing or new carrier wants you to change your signaling?
- Thread starter
- #4
MrComputerTelephony
Vendor
I had a big issue with a carrier that changed there switch out.My signaling on my 2400 ICS was originally wink start on inbound and immediate on outbound and worked like a champ for 7 years.The carrier said they could not do wink start signaling on there new Metaswitch,so I set my inbound to immediate start which did not work even though they could do immediate start.And the crazy thing about it was that it worked like a champ on immediate start on outbound,but would not immediate start the inbound trunks.I think there is a protocol issue with these new switches that the NEC DTI card does not like...You may have to change to a PRI to make it work...good luck
- Status
Similar threads
