T1 SLIPs

[Phoneyguy1]

I just installed a Point to Point T1 between an Opt 61 and a Opt 11. I keep getting frame errors, SLIPRP that I read is repetitive framing errors but I don't know what that means. Bell says its not with there circuit. Any ideas what is causing this?

 

[bcmfiftyfan]

Probably get the best responses in the Nortel CS1000 (Meridian) forum.

 

[EddieDuece]

Have you checked your clocking?

 

[Firebird Scrambler]

It's best to post your thread at

http://www.tek-tips.com/threadminder.cfm?pid=798

However, you might need to confirm that you are using the correct protocal that your carrier has provided. Most problems are in this area, along with clocking as stated above. Clocking isn't a problem is the Option 11 or 61 etc already has a PRI circuit with clocking enabled to your local exchange.

If this is the only link for one of the sites, then you need to make sure that clocking is enabled over the link to the other site so that all calls and messaging is in sync.



Firebird Scrambler
Nortel Meridian 1 / Succession and BCM / Norstar Programmer in the UK
Advance knowledge on BCM support

http://www.linkedin.com/in/davidbromley