T1 Setup Driving Me Crazy

[ciskokidd]

Hello All, I have a problem with setting up an internal T1:

I have set it up as follows: DTI E&M Wink ESF B8ZS

I have a DID setup as an ACD DN routed through the T1.

The problem is that I can access the end equipment fine internally, however when I dial the number externally, the end equipment does not recognize voice or DTMF.

I have and SL1 switch.

 

[NTOldTimer]

Make sure you have DTN at the CLS prompt of the trunks I think the default is Dial Pulse (!loco!)

 

[wdhb]

Is your SICA table in LD73 set up correctly for this & does it match the other end. When you say it is an internal T1, do you mean it is a DTI between 2 M1's?

 

[ciskokidd]

Thanks for your posts NT and wdhb.

I have DTN in the CLS.

I'll check the SICA table to make sure both ends match up. I'm a little boggled why it would work when dialing internally and not externally.

The T1 is set up between my switch and a server using a Dialogic T1 card. It is used for dictation puposes.

Maybe my logic is incorrect:

DID from CO set up as an ACDN and NCFW to an RDB.

Is there a way to control the wink times within the switch?

 

[phonedoc]

if the tie line is setup as DID then it wont go. cant jump did to did. make sure TRNX and EXTT are set to yes.

 

[phonedoc]

sorry that was TRNX and EXTT in ld 15 under net-data