T1 E1 PRI troubleshooting diagnostic tool

[GoTellBigDaddy]

Just picked this up from site:

http://www.nbxgroup.com/nbxcommunit...hp?t=966&sid=ec683991f0370359ad1d2210165621de

The Digital Line Card (DLC) diagnostic utility utilizes TCP port 2323 for connection. Firewall settings may need to be adjusted.

The NBX comes with a utility for capturing events the DLC sees.

To access this utility launch a telnet client, or if one is unavailable on your system, use the URL, replacing IP with IP or hostname of the NBX,

http://192.168.2.190/sec_cont/diags/cli.htm

1. Telnet to the NBX using port 2323, example telnet 192.168.2.190 2323 (NOTE: see telnet client documentation for using non-standard ports if you cannot connect)
2. If you are not using the NetSet tool you will need to enter the administrator password when prompted.
3. The NBX requires that a command end with CRLF (Carriage Return + Line Feed), your telnet client may need to be adjusted to do this.
4. After logging in you will need to enter the MAC address of the DLC with which you wish to communicate with followed by a -1. For example, 00:e0:bb:03:73:da-1
5. You will see connecting... followed by a > prompt. This is the diagnostic prompt.
6. Here you can enter commands, note the terminal does not recognize the deletion of characters and you will need to for the instructions.

 

[donporter]

I have an install for 136 phones with the SuperStack 4.3 next week. I will have to check this out with the changes that we are going to make with the T1 at that location.

 

[GoTellBigDaddy]

There's also TEP download in NetSet but according to the online NBX HELP- you must purchase some sort of license to utilize the T1/PRI logging feature.

Are you installing the new DLC with built in CSU ?????