T1 can't be seen by BCM

[acewarlock]

I have a BCM 1000 w/3.6 Clum patch 2.

T1 Mod in center slot and on BUS 6, Dip (4 OFF) when I programmed the Mod I deprovisioned the last 12 channels as i'm only using the first 12. Mod keeps disapearing from the system. under Resources, it's set for trunk but say's unequipped and when I look at it under Diagnostics, Trunk Modules it shows I have 4 modules instead of module 1 as a PRI. it shows 4 moudles as LOOP.

Also I have 1 DSM 32+ on BUS 2, but when I look at the Mod it shows 10 stations on bus 2 and 7 station on BUS 3. the dips are set all (ON) for BUS 2. 3/5 split partial DD.

Why is the 32+ going across 2 BUSSES and Why can't I see the T1???

 

[acewarlock]

Never mind guys I think I know what I did wrong, I was using the wrong Dip Switch sheet. the one I was using is for single density not double density. just a senior moment.