System Monitor Board

[WrongWayFeldman]

I'm working on a cs1000 release 7.5.
Does anyone know how (via command line) to identify all system monitor boards and the loops that they are associated with?
Also, is there any kind of STAT command I can run to see if they are working?

 

[StanleySteamer]

LD 37
.STAT XSM

That will check all the system monitors. You should see a PWR000 message if they are good. You may get different PWR messages if there is a problem in that column. If you don't see a PWR message for a particular column then it may be defective or have a bad connection to the other columns in the daisy chain.
The system monitor doesn't know which loops or shelves it is monitoring. You would have to keep a record of that.

 

[StanleySteamer]

But you can program something in the LOC field for each XPE like C06M3 for column 6 module 3.