System message - SCH1958

[GTexx]

I get the following system message error when I attempt to delete a M3904 digital set: SCH1958 (Command is blocked since Midnight download is triggered for the Taurus set
type).

Is there a way to remove the set from scheduled firmware download/Midnight routines so that it can be deleted?
or
Is there a way to remove any active firmware download schedules for the set types?

thanks.

 

[Firebird Scrambler]

In LD 32 try using the command FDLC. This will stop the system wide flash download.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[glentuntland]

Back to the oldies: anybody have old books that tell how a NT7D67 rectifier gets wired up?

 

[GTexx]

Ok I tried the FDLC command, it seemed as if it took the command. I did not get any errors. However I still get the same error with the set.

 

[Reusser]

type who at the chicken lips prompt > after you 1st login. Possible switch stuck in Midnight routine.

 

[dj4020]

I had same issue on a phone previously you need to reflash the phone in question to clear this. This is caused by a flash that failed in the middle of the upload. After you flash the TN it will allow you to delete it.

 

[GTexx]

Ok Reusser, I did the "who" command, all it showed was the TTY port, Overlay 0, my userID and nothing for SPRT & Monitor....

Dj4020, I'll try pushing the firmware to the unit again and see where that leads.

Tnx.

 

[GTexx]

Thanks for all the input and responses. We completed a patch update and an INI and that seems to have also resolved the issue with the sch-error. I was able to delete the unit. Not sure if it was a patch that fixed it or the 'INI'.