SYSID change after STARTUP

[lvNortel]

Will the SYSID change for a MICS 7.0 with a PRI if I perform a STARTUP but not take the SW out?

"A phone is a phone and not a computer workstation".

 

[silver987]

If you have not downgraded anything and it is just a "STARTUP" you should be ok.

Wayne T

 

[silver987]

But there is always a chance it will default.

Wayne T

 

[norstarboy125]

Honestly I've had it go both ways but in most cases it has stayed the same.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[exsmogger]

SYSID should stay the same, but the PRI Enabler keycode will be wiped out. Hopefully you have a copy of the keycode to input after a STARTUP.

Brian Cox
Georgia Telephone

http://Georgia-Telephone.com

http://www.linkedin.com/in/briancox1952

 

[lvNortel]

Yes, I do but I was hoping there was a way to double check them right on the system. For example if I were to enter them again what would happen? Or if I entered a wrong code what would happen?

"A phone is a phone and not a computer workstation".

 

[exsmogger]

Nothing bad will happen if you try to re-enter the PRI keycode before you do a STARTUP. I've never needed to re-enter a PRI keycode once it was already input, so I don't know what the display will tell you if you try to enter it again.

Brian Cox
Georgia Telephone

http://Georgia-Telephone.com

http://www.linkedin.com/in/briancox1952