Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Syntax error on drill through...

Status
Not open for further replies.

NJCam

Programmer
Sep 10, 2001
12
US
I've written a report (whose IQD was used to build the cube) and I'm trying to drill through to it from the cube.

If I run the report alone, everything's fine... if I drill through to the same report, I get the following error from Impromptu:

"Error Number -239:

DMS-E-GENERAL, A general exception has occurred
during operation 'prepare request'.
DMS-E-SS_SYNTAX, A syntax error was detected near ','."

Anyone have an answer or a workaround? I've tried setting the drill through option at the measure level, cube level, and both... and still nothing.

Thanks in advance,
- Cam
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top