I have downloaded a flash presentation that I would like to modify for personal use, just to play with the content and the Flash program. It’s a flash intro about over 1180 frames, at first the into brings in texts from both sides in a mix and then forms the names or texts, two lines three words. I figured out that the characters are created as symbols and I learned to find then in the library, matter of fact all of the flash texts & pictures are stored as a symbol, almost 1600 of them. This is my question I want to replace the symbol text at the beginning of the flash intro, is there a way that I can replace one text and the program is smart enough that it will replace the texts in all or designated frames. Frames 20-45 have the texts, do I have to change each text in each frame???
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Symbols & Changing Texts
- Thread starter jamesch
- Start date
Might work... Depends on how it's all done! Difficult to say without seeing the .fla.
Regards. Affiliate Program - Web Hosting - Web Design
After 25,000 posts, banned on FK, but proud not to have bowed down to them!
Regards. Affiliate Program - Web Hosting - Web Design
After 25,000 posts, banned on FK, but proud not to have bowed down to them!
- Thread starter
- #3
I'll give you the web site address and you tell me how difficult. I have no idea!
Again, I just want to learn from this site, not use or reproduce it on another site.
Again, I just want to learn from this site, not use or reproduce it on another site.
- Status