Symantec 200r Network Address Translation 1

[Mootaba]

I am trying to setup NAT on this 200r but I can not find a place to enter the external IP and the Internal IP addresses. According to the documentation I should be setting up a Custom virtual server but this does not seem right. How or where do I set up the IP mappings.

 

[smallProgrammer]

hello,
i cant help, but i hope you have recieved some help on this topic. alot of time past since your post so i would like to know how you solved your problem, because i have the same problem.
thanks alot
charles=)

 

[SefLogic]

Hey Mootaba & smallProgrammer,

This only way you can redirect network traffic from the external interface to an internal server is by using Virtual Servers option on the SFVPN. You can also create Custom Virtual Server if the predefined ones do not list the service you want.

I hope this helps a little.


How to allow external traffic to internal computers with the Symantec Firewall/VPN Appliance

http://service1.symantec.com/support/ent-gate.nsf/docid/2001091011053054?Open&src=w

Good Luck,


tips on fixing any problem in the world
1. Check google / google-groups
2. check the vendor support page
3. get a book on the topic