Sx200s Disa trunk access with account codes over PRI

[mitelritz]

SO im trying to be able to set up Disa dialing from SITE A----- to SITE B

but all i get is just dial tone no dtmf digits going through everytime (execpt if i manually enter the digits after i have dial tone seems like the system is not sending digits)

site A has a pri with a block of DIDs

and SITE B is set up with a disa trunk (form 15)with Special DISA account code of 1234


when i call from my office or my cell phone it works fine....

2224444*91234*96200


i had it set 2 ways 1st was to have form 31 (system abbreviateddial)
to dial a speed call when i had a did number 6200 forward to a sc600

sc 600 had in it

92224444*91234*96200

where dialed number *9 for pause 1234 for account code access and 6200 for the ext
________________________________________________

then i tried the ARS route set up ars
then in form 22 (digit mod)

i put in 2224444*91234*96200
and in many different flavors like *02 or *05

i also even checked auto supervision on the pri side

*2
i checked the Nfolio view doc to see on how to set up analog networking not to clear on a few things.

and i remember i had this same issue with a 3300 and i figured it out with the account code over isdn by selecting a tone to go with the digits outpulsing but the 200s a different beast so i checked all the COS options and System Options

thats why im stuck now haha

 

[nytalkin]

Not too smart to put your disa access on the internet but...............check the cos of the disa extension and particularly the trunk to trunk access.


NO GOOD DEED GOES UNPUNISHED!

 

[kwbMitel]

Vague memory on this.

I believe you need to enable the COS option for Enhanced Answering Position in the COS of the Trunk. (606?)

Without it you get issues with receiving digits.

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.