SX200 ICP Paging Across ip trunks

[mitelritz]

Need a little assistance on programming the ICP from the main site to page via the default page zone access code at the remote site.


Currently TRIED-
ext to speedcall with FAC **12 didnt work
Disa to the remote site then the FAC (*12)
in form 2 i tried setting the Feature access code of the extension over the ip trunks. 5xx

main exts are 2xx
remote exts are 5xx


set my COS for my ip trunks (default 7)
page zone access all set page
and checked all settings for paging


and this is for main site to remote site

at the remote site theres page port hooked up to the amp.

i was trying to put an ext in the ext field in form 18.

Thanks

 

[nytalkin]

Look at y our Interconnect Restrictions

30 years and it's still true.....NO GOOD DEED GOES UNPUNISHED!

 

[mitelritz]

Yes i had everything allowed everytime i install a system i enable everything to access eachother.

 

[kwbMitel]

I do not believe you can page via DISA.

Have you tried using ARS to get the call to the remote system?

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.

 

[mitelritz]

snazzy i got it to work by sending a speed call across the ip trunks...