SX200 Enable key for Night Service in specific tenant group

[JimHilton]

Hey all, I've run into a bit of a mystery. I have a tenant group that has diff hours from the "normal" users. The programmers from before did set a key appearance to toggle night service, but i accidently deleted the set and have lost that programming.

The set is a 4025 and ten grp is 7. I went through form 9 and check all the options to set a key to toggle night service but nothing was obvious.

The set can do it via the superkey, but I'd like to give them a key appearance.

Thanks!

Jim

 

[kwbMitel]

The Manual says that the key is programmed as a feature key. The same method used for a DND key or Headset mode for e.g.

If you can't see it via CDE try programming via the superkey directly on the set.

Don't forget that the set needs to be in the tenant that it controls.

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.

 

[JimHilton]

Hi, yes you are right, didn't see it (or missed it) in CDE but was able to pgm the key to day/night1/night2.

Thanks!!