SX200 AX ICP - Program Buttons on 5540 console?

[SimpleRhyme]

Hello,
Working on an sx200 AX ICP rel 5.0.2.12. Is there any way to program buttons on a 5540 IP console? It's not being use for call handling so I would like to program speed dials or features....seems like my choices are limited when I go into function > ATT function.

Thanks!

 

[jabbo99]

I don't think 5540 IP consoles support speed dial keys.

 

[SimpleRhyme]

No speed dial..... so how about a feature on one of the keys?

 

[jabbo99]

Don't think you are able to program feature buttons on a 5540 IP console either. What features were you trying to program on the 5540?

 

[kwbMitel]

There are macro keys - I'll have to look this up

BRB...

Whoops, forgot the Macro keys are only supported on the Superconsole 1000.

Answer is no for the 5540

**********************************************
What's most important is that you realise ... There is no spoon.

 

[SimpleRhyme]

Like I said before, it's off to the side and not involved in any call handling but if someone was standing next to it and wanted to *09xxx directed call pick up...it would be nice to put it on a button.

Thank you both for checking!

 

[jpruder]

Some cool things can be done with abbreviated dial, depending on setup and conflict. I usually use a single digit access code where such things like *3 can be used. It depends upon how you use the speed calls. Say you program the site such that they dial 4 digits for a speed dial and it is access code+900-999, this leaves you with access code 1-8 or perhaps 0-8. In access code 1 you could have the *09 although it would be **09 followed by *303 if memory is correct...this would then dial the pickup code followed by the next 3 digits.

This is why I make any vm related speed dials the full 3 digit values