SX200 AX ICP>Emergency and Hotline Phones

[jabbo99]

Can emergency (elevator, pool) or hotline(business center) phones in a hotel be programmed to ring different LDN keys on the console or sub attendant? I know it can be done in a 3300 AX. I want each one to ring the different LDN keys once the handset on the phone goes off hook. At first, I was going to set up Priority Dial 0 in the Call Rerouting Table to an LDN key and enable priority dial 0 in the COS. Then it hit me that all hotline and emergency phones would ring that one LDN key.

I'm thinking I need to set up a COS for emergency and hotline phones but I realize that I'll run into my initial problem of calls ringing the LDN key. Please advise.

Thanks

 

[pandabear1]

you can use manual line in the cos, option 228, and then give each extension a different tenant, in the tenant form add the LDN you want in the station dial 0 to route to

 

[jabbo99]

Will this require someone to dial 0 or when the phone goes off hook, it rings the LDN assigned to 0?

 

[jabbo99]

Nevermind pandabear1. I understand what you're saying. Thank you for the input.

 

[kwbMitel]

Creative solution just in case for what ever reason you need the phones in the same tenant

Just showing off -

Set the Dial zero routing for the phones via priority dial zero to be a speedcall

Set the Speedcall to something like the following:

1***8​

[ul]
[li]1 = Dial the digit 1[/li]
[li]** = Dial the digit *[/li]
[li]*8 = Dial the calling extension number[/li]
[/ul]

This way each extension would dial a different dial zero route point that is it's own extension prefixed with the digits 1*

ext 111 would dial 1*111
ext 201 would dial 1*201

Each LDN could then be configured accordingly

**********************************************
What's most important is that you realise ... There is no spoon.

 

[jabbo99]

The GM informed me that all phones in the building must be able to dial 911. Therefore, a hotline will not work in some cases. Normally, I would program a common area phone as I stated above: set up as a hotline to ring an LDN key. However, with the requirement that all phones must dial 911, a hotline may not work. Is there a way to set up a delayed hotline that has the ability to dial only 911? Well, you'd set it up to only dial 911 via COR. But the delay part?

Thanks

 

[jabbo99]

I forgot to add that a select few of the common area phones cannot dial internal room numbers as well.

 

[pandabear1]

you can program the 911 in form 26 nested to "emergency" and when the call goes out to 911 it can alert the console or digital/IP device(s). You can restrict all outgoing calling except 911 through ARS. there is a cos option 202 in the cos of the devices you want to receive the alarm and if a digital/IP phone program an alarm key.
console cos would have options 102 and 108
I am not sure how to setup a delayed hot line, I would have to think about that one, possibly someone else knows that one.

 

[jabbo99]

Got it. The delayed hotline is just an idea and not a requirement so it's not a priority. Thanks

 

[libellis]

Delayed Hotline

http://www.tek-tips.com/viewthread.cfm?qid=1622234

 

[libellis]

Whoops - sorry for the post - just realized you have an SX200 AX