Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Westi on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SX-200ICP rel 5 - Monitor Digits on Embedded PRI 2

Status
Not open for further replies.

kwbMitel

Technical User
Oct 11, 2005
11,505
CA
Does anyone know the exact process for monitoring the PRI digits.

I know you have to enter a command in the comments field similar to +dispcall but I forget which form and what exact format.

I would then open the console on port 2002

Any help would be appreciated.

**********************************************
What's most important is that you realise ... There is no spoon.
 

this is from a tech bulletin:
06-5106-00046

With the introduction of the PRI on the embedded modules on the SX 200 ICP, the method in which to activate the debug commands have changed. On the NSU or the PRI card, you would connect directly with a serial cable and type commands such as option +dispcall to see different types of information for troubleshooting.
With the embedded PRI module, these commands are input in CDE form 43. To view the output of these commands, you have to secure telnet to the SX200 ICP on port 2002.
This is a list of the commands which are useful for troubleshooting.

pri chan state It gives a snapshot view of status of the link. Similiar to the Option state on the NSU

pri discall on It allows you to see info on calls in both directions Similar to the option + dispcall on the NSU

pri discall off Turns off the output of this information Similar to option - dispcalll on the NSU

pri cause on Allows you see the cause code information Similar to option + cause on the NSU

pri cause off Turns off the output of this information Similar to option - cause on the NSU

tsp l2l3 on Turns on the Layer 2/3 trace Should only be done on Request from Mitel
This is the only one that really shows anything

tsp l2l3 off Turns off the Layer 2/3 trace

To turn these commands on or off, log into CDE form 43 and go to the bay/slot of the link you want to run these command on, and tab over to the COMMENTS field and type them in. To view them, secure telnet to port 2002 on the controller.
Log into installer level only using proper telnet
 
Exactly what I was looking for. Star worthy.

**********************************************
What's most important is that you realise ... There is no spoon.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top