Hi!
I do tech work for a school which has an older SX200 Cabinet System...
They are moving their telephone services from the current PRI (connected trough CSU/DSU) connection
to 2 analog POTS lines. They are currently configured to run off the PRI/T1 circuit..
Their SX200 has LG/GS TRUNK CARD with 6 Ports that had been pulled out.
I connected the card into the system and punched down the lines on the corresponding block.
The card stays in alarm all the time.
I have connected to the system using HyperTerminal on the Maintenance Port.
What changes do I have to make to the system to start accepting calls on that LG/GS card.
What changes do I have to make for the system to pick up a POTS line when 8 is dialed
on the phone?
Any help would be greatly appreciated. I have a lot of telephone experience with older
PBX systems, just never worked on a Mitel before..
Thank you,
Bo
Modify message
I do tech work for a school which has an older SX200 Cabinet System...
They are moving their telephone services from the current PRI (connected trough CSU/DSU) connection
to 2 analog POTS lines. They are currently configured to run off the PRI/T1 circuit..
Their SX200 has LG/GS TRUNK CARD with 6 Ports that had been pulled out.
I connected the card into the system and punched down the lines on the corresponding block.
The card stays in alarm all the time.
I have connected to the system using HyperTerminal on the Maintenance Port.
What changes do I have to make to the system to start accepting calls on that LG/GS card.
What changes do I have to make for the system to pick up a POTS line when 8 is dialed
on the phone?
Any help would be greatly appreciated. I have a lot of telephone experience with older
PBX systems, just never worked on a Mitel before..
Thank you,
Bo
Modify message