Switch Extensions Instead Of Repunch On 66 Block? 1

[osurob]

Is there a simple way through MATWorX 3.61 to switch Extensions rather than going to the 66 block and repunching both jacks when two people switch offices and want to keep their extension?

Boy I’m full of questions today, sorry. It’s all you guy’s fault though… cause you always come up with the answers!

Thanks Again Guys I honestly Appreciate All Your Advice And Assistance

 

[neax]

In MATWorX Studio, Go to STATION then to COPY/MOVE STATION then to SWAP TWO STATIONS. This tool will swap to stations.

 

[osurob]

NEAX that is a lifesaver!!! Thank you for all your help. Have a great weekend.

 

[neax]

osurob... Help a brotha out and Click the "Thanks neax for this valuable post!

 

[rdisneyman]

When I copy an extension MATWorX I still need to re-program E601 E602 and the line2 virtual extension. Am I doing something wrong in my initial programming?

Here is a script I run to program a new ext.
10 len ext
11 vlen vext
1303 ext 0
1222 ext 0
1223 ext 0
73 ext bin
9000 ext,01 ext
9000 ext,02 vext
93 ext ext
E601 ext vext
E601 vext 11
E602 ext 11
E602 vext 11
740 4bin18 11
740 4bin19 6B

 

[neax]

Yes, you will need to re-do the Call Forwarding.

 

[mextera]

Hey rdisneyman don't forget that when you run this script to build a new station thats fine but if you delete a station and run this you have to still check to see if the station was programed in cm 16,17 and 18.