Swapping Micros Computer to another restaurant, printers not working

[mclaughlin21]

So, I took a micros system that I had at one restaurant to a new one I'm trying to get open. I have two more system here to network with it, three printers (two thermal, one dot matrix), two cash drawers and two customer displays. After having everything networked through ethernet cabling, I cannot get any of the printers to print, the displays to display but the cash drawers will open,

 

[DrZogg]

You have to enter the devices into the Network Node table, including the ports and baud rate. Then add them to the device table, from there add them to the User Workstation table. The User Workstation table includes config for peripheral devices (cash drawers, rear display, mag card reader).
Printer setup depends on the interface card as how they are configured. They must be added to the device table also

 

[pkuck]

I'm doing the same thing, but am having problems with only the kitchen printers. Everything is in the network node correctly and in the workstations. I'm afraid in might be a wire issue. Is there a way to check communications/connections?