Swap out processor 1

[G3rtech]

I have a bad CKE4 HV01 Legend 7.0 V10.0 and a replacement CKE4 HV02 Legend 7.0 V10.0 When I try and do a restore I get a mismatch error. Is the HV 1 and 2 my problem?

Thanks!

 

[TouchToneTommy]

You may have to put the new processor in the same mode as the old one, and if the programming port had been moved from #01, change that as well.

 

[G3rtech]

Thanks for the information. I tried that but no good. After a few days of swapping out boards and backplanes I narrowed it down to the software. I used winspm to get my station data then I nuked the system and re-programmed. All is well now. Thanks for the help and have a good week.

 

[merlinman]

Well, I guess I missed your original post.

The REPLACEMENT processor probably had some translations in it that made it think the "BOARDS" didn't match what you had installed.

All you needed to do was to TOTALLY erase the REPLACEMENT Processor and then use your Back Up Card to restore it.

Hopefully, you didn't have to do a great deal of programming.

http://home.comcast.net/~merlinman

 

[G3rtech]

No just 20 stations and not allot of bells and whistles. Thanks!