SV9300 and PRT blades CM05 Y=2 1

[Balzamalex]

Hi
At my stand SV9300 I set up the ISDN PRI test line, and I met the command CM05 Y=2
This is a bit unclear for me.
Show me an example, what value should I set if PRT cards are installed in Slot 1, 3, 5 Unit 01?
And another example - PRT installed in 5 and 11 slots of Unit 1 and slot 2 of Unit 2?
I need an example only for the command CM05 Y = 2. I do not need to show all the programming!
Thank you.

 

[belevedere]

Assign the number of Highway Channels for ISDN data communication.
NOTE 1: When the second data of this command is set to NONE (No data), the PRT blade for ISDN data communication
must be accommodated to the base slot (Slot No. 01/07/13) of each line trunk chassis.
In this case, the available Highway channels for data communication are the only first 16 channels.
NOTE 2: When this command is set, additional chassis time slots are used.
Example: CM05 Y=2>0101: 12 will use 12 chassis time slots.

If you load up one chassis with too many PRI cards, it can run short of time slots (I think each cabinet provides ~ 108 time slots). This allows you to spread out the cards using time slot from other cabinets. It's rarely used since the default usually is good.