SV8500 Asyd SSystem 1 Index 65 seem shows Data FF Lsyd Sys1 Ind FF(11111111) FDATA 00 AND MDATA 00

[WildBil]

SV8500 Asyd SSystem 1 Index 65 seem shows Data FF Lsyd Sys1 Index 65 = Data = FF(11111111) FDATA = 00 AND MDATA =00
Could this be causing a limit on how many Trunk Routes we can Have! Please share what you may think on this!
All has been tested but think possible some one has disabled Receive OF QSIG limit!

 

[belevedere]

ASYD sys 1 index 65 set to FF should allow the maximum of 255 trunk routes. Does the system block high numbered routes in ARTD?

 

[WildBil]

Yes 83 and 85 but also had pri 16 and 18 Same Problem all these programmed last after others that are working fine route 33,35, 53 ,55 ,57,75 and 77 working fine just new routes that were programmed after these just as if you don't have the Receive side Punch Down no hand Shaking going on loop back to other Pri test ok and layer1 Error goes off cards swap replace cables ran patch cable to Cisco Switch direct same problem Cisco test ok with Loop back plug

 

[WildBil]

Possible system reboot needed hasn't been rebooted since upgraded from NEAX 2400 TO sv8500 2014/2015