miteshrathod85
Programmer
Sir,
Any one give me sv 8300 caller Id programming
With command please
Any one give me sv 8300 caller Id programming
With command please
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sv8300 callerid programmin
- Thread starter miteshrathod85
- Start date
- Status
belevedere
Instructor
Incoming? Outgoing? By trunk? By individual station?
- Thread starter
- #3
miteshrathod85
Programmer
Incoming trunk caller Id and ext analog phone caller id
belevedere
Instructor
What kind of trunking? Analog Potts, ISDN PRI?
Analog trunks can only be loop start for incoming caller ID and your CO provider must be sending the FSK signal.
ISDN PRI trunks receive caller ID as long as your provider has not restricted it.
In either case no system programming is required.
Station Application
Single Line Telephones with CLI display function (CLI based on FSK: ETSI EN300 659)
Operating Procedure
No manual operation is required.
Analog trunks can only be loop start for incoming caller ID and your CO provider must be sending the FSK signal.
ISDN PRI trunks receive caller ID as long as your provider has not restricted it.
In either case no system programming is required.
Station Application
Single Line Telephones with CLI display function (CLI based on FSK: ETSI EN300 659)
Operating Procedure
No manual operation is required.
- Thread starter
- #5
miteshrathod85
Programmer
Ok sir, but give me sir programming with command
belevedere
Instructor
There is no programming required for incoming caller ID to multiline telephones.
- Status
Similar threads
- Locked
- Question